Spec Sheets
RTS FLC30 ASSEMBLY (SPC7305) NEWSPQ.PDF
Fixture Details
Family:
US
Features Benefits:
Height21\' to 41\'; PoleThe pole shaft conforms to ASTM A595 Grade A or A572 Grade 55 with a constant linear taper of 0.14 in/ft.; Fluting ProcessThe tapered shafts are cold rolled over a precision hardened steel mandrel to form the 8 Sharp flutes. The flutes are uniform and equally spaced throughout the process. The termination of the flutes is no greater than 1.50 radii transition into the round section of the shaft. The results of this fluting process are flutes with architecturally pleasing radiused terminations and crisp uniform flutes.; Linear Flute LayoutPoles are provided fully fluted from pole top to anchor base. Consult factory for custom flute start and stop locations.; FinialA decorative spear finial with hardware is provided.; Luminaire ArmLuminaire arms are made from 2 schedule 40 pipe (2.38 OD) with a minimum yield strength of 36,000 psi. Double luminaire arms are oriented 180 apart. For other orientations and scroll options please consult factory.; HandholeA covered handhole and grounding provision with hardware is provided.; Nut CoversDecorative anchor bolt nut covers with hardware are provided.; Anchor BaseThe cast anchor base (base plate) conforms to ASTM A27 Grade 65-35.; Anchor BoltsAnchor bolts conform to ASTM F1554 Grade 55 and are provided with two hex nuts and two flat washers. Bolts have an L bend on one end and are galvanized or zinc-plated carbon steel or stainless steel.; HardwareAll structural fasteners are galvanized high strength carbon steel. All non-structural fasteners are galvanized or zinc-plated carbon steel or stainless steel.; FinishStandard finishes are galvanized, prime painted or any of Valmonts V-PRO Protection Systems. Additional finish options available upon request.
You must log in to add this fixture to a project!